Advertisement
Accessing the Torpedo
1.
Power on the Torpedo.
2.
The Torpedo comes pre-configured with the following default settings:
IP Address
10.5.1.2
3.
Open a Web browser, type the IP Address for the Torpedo into the URL address bar, and press Enter.
4.
Log in to the Torpedo Web Interface, using the default username and password.
Configuring the LNB and DiSEqC settings (Dish Setup, DVB-S/S2 only)
NOTE
There is no LNB configuration on DVB-T/T2 systems, so Dish Setup is not required.
1.
Click
S
from the main menu and then click
YSTEM
The Dish Setup page opens, as shown in the following example.
2.
Specify the Low Noise Block (LNB) settings, as required for your system.
3.
If your RF network contains DiSEqC (Digital Satellite Equipment Control) switches, it may be necessary to set
the switches here to configure the RF path, i.e., to specify which RF source reaches the Torpedo.
HVS-ID-QS-TORP-220, Issue 02
Subnet Mask
Gateway
255.255.0.0
10.5.0.1
D
ISH
Username
admin
S
from the sidebar menu.
ETUP
Torpedo Quick Start Guide
Accessing the Torpedo
Password
manager
Page 3 of 7
Advertisement
