Included in the package Part Description Base Lateral Shelf Rear Panel Feet Hardware A = 16x B = 12x C = 08x D = 08x E = 08x F = 02x G = 34x H = 01x I = 01x J = 01x K = 08x Tools needed (not included)
Page 3
11 lb 11 lb 11 lb 11 lb 11 lb A = 16x Connect the part (12) onto the part (01) with the hardware (A). 1.0 Bookcase Rockefeller...
Page 4
C = 08x D = 08x E = 08x K = 08x Connect the parts (03) onto the parts (01 and 02) using the hardware (C + D + E). Apply the hardware (K) on the hardware (E). B = 12x Connect the parts (04) onto the parts (03) with the hardware (B).
Page 5
G = 34x Connect the part (05) using the hardware (G). 1.0 Bookcase Rockefeller...
Page 6
Attention! Tipover System F = 02x H = 01x I = 01x J = 01x wall Then, pass the hardware (J) through the hole of the part (05) as shown in the figure above. You will need a pencil to mark where you First, approach as close should drill the wall with a 3/8"...
Need help?
Do you have a question about the Rockefeller 1.0 Bookcase and is the answer not in the manual?
Questions and answers