7.3
Ethernet 1 and Ethernet 2 Network Settings
•
Enable DHCP to automatically assign IP Settings or modify the IP Settings manually as needed, via these fields: IP
Address, Netmask, Gateway, and Domain Name Server1/2.
NOTE: If connected to a router, set the Gateway to the same IP Address as the router.
•
Click Save to record and activate the new IP Address.
•
Connect the FieldServer to the local network or router.
NOTE: If the webpage was open in a browser, the browser will need to be pointed to the new IP Address of the
FieldServer before the webpage will be accessible again.
QuickServer FS-QS-3X10-F Start-up Guide
21
Need help?
Do you have a question about the QuickServer FS-QS-3 10-F Series and is the answer not in the manual?