WERKU WK401030 Original Instructions Manual page 4

ENG ORIGINAL INSTRUCTIONS
aged accessory. After inspecting and installing an
accessory, position yourself and bystanders away
from the plane of the accessory and run this power
tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart
during this test time. Position the cord clear of the
accessory. If you lose control, the cord may be cut
or snagged and your hand or arm may be pulled
into the accessory. Regularly clean this power
tool's air vents. The motor's fan will draw the dust
inside the housing and excessive accumulation of
powdered metal may cause electrical hazards.
STORAGE.
Store power tools out of reach of children and not
allow the handling of power tools to people unfami-
liar with the tools or these instructions. Power tools
are dangerous in the hands of untrained users.
MAINTENANCE.
Check moving parts for misalignment or binding,
there are no broken parts or other conditions that
may affect the operation of power tools. Power tools
are repaired before use when they are damaged.
Many accidents are caused by poorly maintained
power tools. Use power tools, accessories and tool
tips, etc. according to these instructions and in the
manner provided for the particular type of power
tool, taking into account the conditions work and
work to develop. The use of the power tool for appli-
cations other than those intended could result in a
dangerous situation. Please check your power tool
serviced by a Werku
only identical replacement parts. This will ensure the
safety of the power tool is maintained.
CHECK CONDITION.
Make sure that all the screws in the power tool
are perfectly tightened. In cold climates or when
the power tool has not been used for a period,
allow the power tool to warm up by leaving it to
run empty for a few minutes, to ensure that all in-
ternal components are perfectly lubricated. Make
sure that the possible installed accessories are
perfectly fitted in place.
BEFORE STARTING WORK.
Make sure that the power tool is firmly supported
before using. Check that no one is standing be-
neath you when using the power tool in high areas.
official repair service using
®
Keep your hands away from all moving parts of
the power tool. Use auxiliary handles, if supplied
with this power tool. Loss of control can cause per-
sonal injury.
DURING THE OPERATION.
Do not leave the power tool operating without ha-
ving it firmly fixed. Only turn it on when you are
sure you have full control over it. Do not point the
power tool at anyone while in use. When operating
the power tool will produce vibrations. The screws
may gradually come loose, and possibly cause
faults or accidents. Keep your hands away from
all moving parts of the power tool.
AT FINISH WORKING.
Do not touch the possible accessories installed in
the power tool after use. It may be hot and cause
burns. Some materials worked with may contain
chemicals or toxic components. Avoid inhaling
these substances or allowing them to come into
contact with your skin. Use PPE designed to pre-
vent and protect against incidents of this kind.
DESCRIPTION OF THE PRODUCT.
The cordless reciprocating saw has been designed to
carry out jobs of cutting on wood, metal, drywall and
other soft materials. Refer to this plan to familiarize
yourself with the cordless reciprocating saw before use.
1
2
3
1. Pivot shoe.
2. Quick-release blade clamp.
3. Shoe release lever.
4. Lock-on button.
5. Switch trigger.
6. Battery.
USE INSTRUCTIONS.
Before starting the cordless reciprocating saw,
we recommend that you carefully read all of
the instructions as indicated. Please respect all
regulations regarding the prevention of accidents,
health and safety directives, laws and applicable
restrictions
4
English
for work places. The
4
5
6
cordless