modway EEI-2140 Assembly Instruction

Armless sofa

ARMLESS SOFA

Thank you for purchasing the ARMLESS SOFA!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the sofa, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of small children.

Component:

Back Cushion

Seat Cushion

Sofa Body

Leg

Page 1 of 3

Table of Contents

Need help?

Do you have a question about the EEI-2140 and is the answer not in the manual?

Page 1 ARMLESS SOFA Thank you for purchasing the ARMLESS SOFA! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the sofa, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 ARMLESS SOFA STEP 1: Put the Sofa Body (3) upside down on a carpeted or padded area by two adults to make fully visible the corners. Position one of Legs (4) at one of the four bottom corners. Screw the Leg (4) into the bottom of Sofa Body (3) as shown. Repeat the same steps for the other remaining three Legs (4).
Page 3 ARMLESS SOFA STEP 3: If you want the armless sofa combine with other section. Put the assembled Sofa Body (3) upside down on a carpeted or padded area. Screw the Clip into the bottom of sofa right end by using screws. Using a Phillips head screw driver to tighten the screws.