modway EEI-2140 Quick Start Manual

Armless sofa

EEI-2140 ARMLESS SOFA

Thank you for purchasing the MODWAY ARMLESS SOFA!

Before you start, here are some helpful advice:

1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by step instructions.

2. Owing to the size and weight of the sofa, we recommend that it is assembled by two adults on a carpeted or

padded area, in the room that it is intended for. Approximate time: 30 minutes.

3. Please do not use any tools other than those provided or recommended in these instructions.

4. Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

component from time to time,so please save the tools that have been provided.

6. Please keep all pieces out of reach of children.

1. Back Cushion x1

Customer Service 908-368-1025 I www.modwayfurniture.com

2. Seat Cushion x1

3.Sofa Body x1

4. Leg x4

Page 1 of 3

Table of Contents

Need help?

Do you have a question about the EEI-2140 and is the answer not in the manual?

Page 1 EEI-2140 ARMLESS SOFA Thank you for purchasing the MODWAY ARMLESS SOFA! Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by step instructions. 2. Owing to the size and weight of the sofa, we recommend that it is assembled by two adults on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI-2140 ARMLESS SOFA STEP 1: Please put the Sofa Body (3) upside down on a carpeted or padded area by two adults to make the corners fully visible. Open the Zipper on the bottom of Sofa Body (3) as shown, take out the packages of Legs (4), then close the Zipper on the bottom of Sofa Body (3) .
Page 3 EEI-2140 ARMLESS SOFA STEP 3: If you want the armless sofa combine with other section, put the assembled Sofa Body (3) upside down on a carpeted or padded area. Screw the Clip into the bottom of sofa right end by using screws.Using a Phillips head screw driver to tighten the screws.