Additional Notes About Direct Monitoring; Headphone Source Selection; Troubleshooting - Connectivity ConnectAUDIO 2 User Manual

Additional Notes About Direct Monitoring

The Direct Monitoring LED indicator will change to
l
to make adjustments. This indicates that Direct Monitoring is still enabled, but not available for edit-
ing.

Headphone Source Selection

Headphone Source Selection is a feature of the ConnectAUDIO
between the computer output channels being monitored on the headphones.
One touch switches the headphone source between channels 1/2 and channels 3/4. Note that channels
1/2 are always routed to the analog outputs on the back panel, regardless of the headphone source selec-
tion.
To change headphone sources, press the 1/2_3/4 button on the Touch Panel.
indicates that output pair 1/2 is selected
l
indicates that ouput pair 3/4 is selected
l

Troubleshooting

I don't hear any sound from the speakers or headphones connected to the interface
Make sure that you have
transmitting audio is selected on the Touch Panel.
I've turned on direct monitoring but I'm only hearing the computer output, not the analog input.
Verify that you have selected one or more of the analog inputs for monitoring. If neither input is selected,
you will only hear the computer output. Refer to the
2/4
ConnectAUDIO User Manual
set up output levels on the unit. Verify that the output pair over which your DAW is
orange any time you press the In or Out buttons
2/4
that allows you to easily switch
Direct Monitoring section for more information.
17