Out/Phones Meter Modes; Setting Up Inputs; Assigning Input Modes - Connectivity ConnectAUDIO 2 User Manual

5. Play the audio track in your DAW and move the Rotary Control Dial slowly until you begin to hear
audio in your speakers or headphones. Continue adjusting the dial to increase or decrease the level
as desired.

Out/Phones Meter Modes

There are two meter display modes. Pressing the Out or Phones buttons multiple times allows you to
toggle between:
Signal Level mode, indicated by the
l
react to the input signal in real time.
Gain Set mode, indicated by the
l
clockwise or counter-clockwise motion of the Rotary Control Dial.

Setting Up Inputs

Assigning Input Modes

With your interface connected, and your DAW open with the ConnectAUDIO
put device, follow these steps to set up an audio input source and pass the audio signal to your DAW from
2/4
your ConnectAUDIO
Dynamic Mics, Instruments or Line-Level Sources
1. Touch 48V/Inst
2. Touch 1, 2 or both to assign the
green for inputs to which
2/4
ConnectAUDIO User Manual
green
red LED. The LED meters display the gain setting and respond to
:
twice, to set Inst as the Input Mode. The indicator light will display red.
Inst
Inst mode has been assigned.
Figure 1: Input Assign mode;
LED. The LED meters display VU (signal level) and will
Input Mode to an input. The input indicator light will turn
Inst mode assigned to Input 2
2/4
selected as the Input/Out-
13