Setting Up The Interface; Setting The Output/Phones Level - Connectivity ConnectAUDIO 2 User Manual

Setting Up the Interface

1. Connect the interface to your PC, Mac, or iOS device. (Note that a separate Apple Lightning-to-
USB 3 Camera Adaptor is required for iOS devices)
2. Verify that the interface is powered ON: Your ConnectAUDIO
does not require an external power supply. Once connected, the default indicator lights on the Touch
Panel Display will illuminate, indicating that your ConnectAUDIO
use.
3. Check for firmware updates: Go to the
fig Configuration and Control software, and open iConfig. iConfig will check the firmware version of
your ConnectAUDIO
iConfig also lets you view information such as the serial number and hardware version of your unit.
Note: We recommend updating to the latest firmware, but you can skip this step and return to it later,
if you prefer.
4. Enable the interface in your DAW: In your DAW, select the ConnectAUDIO
Output device.

Setting the Output/Phones Level

Once you have hooked up the ConnectAUDIO
ware, follow these steps to set the Ouput/Phones level:
1. Set up a track in your DAW that contains audio and route it to channels 1/2 of the
2/4
ConnectAUDIO
2. Verify that the Phones button LED is green, indicating that channels 1/2 are selected.
3. Touch Out or Phones, according to your monitoring setup; either amplifier/speakers or headphones.
Touch once to enable Signal Level metering mode
metering mode (red
about meter modes.
4. Verify that the 1 and 2 LED indicators in the upper-left section of the panel are lit. In Out/Phones
Mode, these buttons represent the stereo linked output. In Out Mode you can select 1 or 2 individually
and adjust each output separately, if you prefer.
2/4
ConnectAUDIO User Manual
iConnectivity support
2/4
and prompt you to update your firmware if a newer version is available.
2/4
.
LED). Refer to the Out/Phones Meter Modes section below for more information
2/4
2/4
page, download and install the iCon-
to your device and enabled it in your DAW host soft-
(green LED). Touch twice to enable Gain Set
is USB bus-powered and
is powered ON and ready for
2/4
as the Input and
12