Table of Contents
Advertisement
4.4
Electrical adjustment (DVD SECTION)
4.4.1 Test mode setting method
(1) Press POWER button to turn off the unit.
(2) Press the following remocon keys continuously within 2seconds " SET UP " → " 2 " → " 8 " → " ENTER ".
(3) The unit becomes JIG RCU mode.
(4) Press POWER button then press VCR/DVD repeatedly so that the DVD indicator lights up on the front display panel.
(5) Press the POWER button again to turn off the unit.
(6) Transmit the code " 43-FA " from the Jig RCU.
(7) The power supply of the unit turns on automatically then the FDP shows the region number.
(8) Each pressing of DISPLAY button of the remote controller in test mode as follows.
(9) To release test mode, press POWER key of the front panel.
FDP(Example)
VCR
4.4.2 Method of displayed version of firmware
(1) Set the unit to the test mode.
(2) The version number is displayed in the monitor screen.
OPENING DISPLAY
**_Ver.****_HS/HR_XVC29/*******
Model name
Version of firmware
Destination
Becames test mode
(Region number)
Optimize Front End parameter
CD Laser
DVD Laser
Others
(No.YD052)1-19
Advertisement
Chapters
Table of Contents
