SATA Power Connector
(DC-IN Mode)
(4-pin HDDPWR1)
(see p.6, No. 3)
Serial General Purpose
Input/Output Header
(7-pin SATA_SGPIO1)
(see p.6, No. 25)
LAN LED Connector
(LED_LAN3_4)
(see p.6, No. 13)
Clear CMOS Pad
(CLRMOS1)
(see p.6, No. 11)
22
1
2
GND
GND
+5V
+12V
4
3
SCLOCK
SLOAD
GND
1
SDATAOUT
GND
1
LAN4_LINK
LED_PWR
LED_PWR
LAN3_LINK
Please use a SATA power cable
to connect this SATA Power
Connector and your SATA
HDD for supplying power
from the motherboard, when
using DC-IN mode without
SATA power supply.
*Caution: Misconnection between the
ATXPWR1 and the HDDPWR1 con-
nectors may permanently damage the
motherboard.
This header supports Serial
Link interface for onboard
SATA connections.
This 4-pin connector is used for
the front LAN status indicator.
This allows you to clear the
data in CMOS. To clear CMOS,
take out the CMOS battery and
short the Clear CMOS Pad.