Advertisement
Mounting the Controller
CAUTION:
Make certain that you mount the Controller on a vibration-free
surface.
Select the mounting position of the IXP110 Controller, considering accessibility, routing
of wires and visibility of the LED.
Secure the Base to the mounting surface, using four suitable screws and wall plugs
(supplied), nuts and bolts or rivets.
Top Cover Release Mechanism
1.
Remove the top two Thread Cutter Screws (2.2 x 5 mm) from each of the End
Plates.
2.
Insert a flat head screwdriver (maximum 7 mm) into the cut out in either of the two
End Plates. Swivel the screwdriver until the Top Cover makes a click sound.
3.
Insert the screwdriver in the gap (on the side of the IXP110 Controller) between the
Top Cover and the Base. Swivel the screwdriver again, to release the Top Cover
from the Base.
IXP343-0-0-GB-07
Figure 3: Front End Plate
Figure 4: Back End Plate
Blank Space
April 2009
Page 5
Advertisement
