Error Displays - Clarion CZ209 Owner's Manual

Problem
No sound
Sound is
interrupted or has
noise.
Device isn't
recognized.
Cannot connect
device to the USB
cable.

9. ERROR DISPLAYS

If an error occurs, one of the following messages is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 2
ERROR 3
ERROR 6
Cause
The device contains no MP3/
WMA files.
The files are not proper MP3/
WMA format.
Files are DRM copyright
protected.
Connectors are loose.
Some USB portable music
players may consume current
that exceeds the USB rating.
In this case, this unit's
overcurrent protection circuit
operates to stop the music
playback.
MP3/WMA files are not
encoded properly.
Device is damaged.
Connectors are loose.
According to the device's
operation state, device may
not be recognized.
Device has been connected
improperly.
Connector is broken.
Cause
A CD is caught inside the CD
deck and is not ejected.
A CD cannot be played due
to scratches, etc.
A CD is loaded upside-down
inside the CD deck and does
not play.
Measure
Record MP3/WMA files properly to the device.
Use properly encoded MP3/WMA files.
See page 11 for details on how to cancel DRM
protection.
Disconnect the device and reconnect securely.
Check operation of portable music player.
Use properly encoded MP3/WMA files.
Disconnect and reconnect the device. If device still
cannot be recognized, try replacing with different
device.
Disconnect and reconnect the device.
Connect the device in reverse direction.
Replace with a new device.
Measure
This is a failure of the CD deck mechanism. Consult
your dealer.
Replace with a non-scratched, non-warped disc.
Eject the disc and reload properly.
21
CZ209