Advertisement
Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1)
Setup for Remote Control
Console Channel Selection
NOTICE
In most cases, the wireless channel should be correctly set from the factory. Use this
procedure if there is a wireless channel conflict.
1. From the setup menu, under "Sensors", select "Cordless Channel Selection".
2. The console channel setting is displayed in the upper left corner. Highlight the desired channel from the
list below it then select "Set Channel".
NOTICE
Channels on other devices such as conventional sensors, CodeLink®, remote indicator,
etc must also be changed at this time.
Page 2 of 7
Advertisement
