Basic Operations; Turn On The Power; Select The Source To Play; Adjust The Volume - JVC RX-E100RSLB Instructions Manual

Basic Operations

This manual mainly explains operations using the buttons and controls on the front panel. You can also use the buttons on the remote
control if they have the similar names (or marks) as those on the front panel.
If operations using the remote control are different from those using the front panel, they are then explained.
• You can also see "Mastering Remote Operations" on page 40.
STANDBY lamp TV DIRECT
STANDBY
STANDBY/ON
1
1

Turn On the Power

Press (or AUDIO button on the remote
control).
The STANDBY lamp goes off. The current
source indicator lights green. The name of the
current source (or station frequency) appears on
the display.
Current volume level is shown here
L R
LPCM
DGTL AUTO
Current source name appears
To turn off the power (into standby)
Press (or AUDIO ) again.
The STANDBY lamp lights up.
A small amount of power is consumed in standby
mode. To turn the power off completely, unplug
the AC power cord.
2
S
elect the Source to Play
Press one of the source selecting buttons.
DVD DVD STB VCR
DVD
: Select the DVD player.
STB : Select STB.
VCR
: Select the VCR.
TV : Select the TV tuner.
TAPE
: Select the cassette recorder.
FM/AM : Select an FM or AM broadcast.
The selected source indicator lights green.
10
Display
RX-E100R
TV DIRECT
DVD
ANALOG L C
CONTROL
LPCM
SUBWFR LFE
DOLBY D
LS S
DTS
SETTING ADJUST MEMORY
D I G I T A L
DVD DVD
D I G I T A L
S U R R O U N D
STANDBY
STANDBY/ON
VOL
STANDBY
STANDBY/ON
TV TAPE FM/AM
Source indicators
HOME CINEMA CONTROL CENTER
STB VCR TV TAPE FM/AM
R PRO LOGIC SLEEP RDS EON TA HEWS INFO TUNED ST AUTO MUTING
DSP
MH Z
DGTL AUTO KH Z
INPUT
RS VOL
INPUT ATT
ANALOG/DIGITAL
INPUT ATT
STB VCR TV TAPE FM/AM
2
Note:
When you have connected some digital source components using the
digital terminals (see page 7), see "Basic Settings" on pages 13, 14,
and 15 to finish the digital input terminal setting and digital input mode
setting correctly before use.
3
A
djust the Volume
To increase the volume, press and hold
MASTER VOLUME
remote control).
To decrease the volume, press and hold
MASTER VOLUME
remote control).
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• The volume level can be adjusted within the range of "0" (minimum)
to "70" (maximum).
• Each time you press the button, the volume level changes by 2
steps from "0" (minimum) to "14" and by 1 step from "14" to "70"
(maximum).
SURROUND DSP
ON/OFF MODE
MASTER VOLUME
3
(or VOLUME + on the
MASTER VOLUME
(or VOLUME – on the