Table of Contents
Advertisement
LTBRZ3-C series | INSTRUCTIONS MANUAL
1.
Disclaimer
Always deploy and store Opto Engineering products in the prescribed conditions in order to ensure
proper functioning. Failing to comply with the following conditions may shorten the product lifetime
and/or result in malfunctioning, performance degradation or failure.
Ensure that incorrect functioning of this equipment cannot cause any dangerous situation or
significant financial loss to occur. It is essential that the user ensures that the operation of the
controller is suitable for their application. All trademarks mentioned herein belong to their
respective owners.
Except as prohibited by law:
All hardware, software and documentation are provided on an "as is" basis Opto
▪
Engineering accepts no liability for consequential loss, of any kind
▪
▪
Upon receiving your Opto Engineering product, visually examine the product for any damage
during shipping. If the product is damaged upon receipt, please notify Opto Engineering
immediately.
2.
Safety notes
Please read the following notes before using this controller. Contact your distributor or dealer for
any doubts or further advice.
This device must not be used in an application where its failure could cause a hazard to human
health or damage to other equipment. Keep in mind that if the device is used in a manner not
foreseen by the manufacturer, the protection provided by its circuits and by its enclosure may be
impaired.
This is a low voltage device. As such, the potential difference between any combination of applied
signals must not exceed, at all times, the supply voltage. Higher voltages may cause a fault and can
be dangerous to human health.
This device has limited protection against transients caused by inductive loads. If necessary, use
external protection devices like fast diodes or, better, specific transient protectors.
When the device is switched off, there is still energy stored in the internal capacitors for at least five
minutes.
When operating the illuminator at the maximum brightness it can get very hot. The illuminator
should be positioned where personnel cannot accidentally touch it and away from flammable
materials. Never exceed the power ratings stated in the manual.
During normal operation, the case temperature may exceed ambient temperature by as much as
25 °C (45 °F). To prevent higher case temperatures, the product can be fixed over a metal plate
V 1.00 - eng
3
Advertisement
Table of Contents
