LTCLHP | instruction manual Table of contents 1. Product overview ..................................... pag. 3 2. Instructions for use ....................................pag. 4 2.1 Operation options ..................................pag. 4 2.2 LED source axial position ................................pag. 5 2.3 How to replace the LTSCHP module ............................pag. 6 2.4 How to replace the LED1W source ............................pag.
LTCLHP | instruction manual 1. Product overview LTCLHP series are high performance telecentric illuminators featuring excellent illumination stability, precise light intensity tuning and easy replacement of the LED source, specifically designed to back illuminate objects imaged by telecentric lenses. LTCLHP telecentric illuminators offer higher edge contrast when compared to diffused back light illuminators and therefore higher measurement accuracy.
LTCLHP | instruction manual 2. Instructions for use 2.1 Operation options LTCLHP telecentric illuminators integrate LTSCHP modules as light sources. LTSCHP LED modules can be operated in two ways: • standard usage option: through the built-in electronics • direct LED control usage option 2.1.1 STANDARD usage option (LED control through built-in electronics) Only continuous mode (constant current) is allowed.
LTCLHP | instruction manual 2.1.2 Direct LED control usage option Both continuous and pulsed mode are allowed; the built-in electronics can be bypassed in order to drive the LED directly for use in continuous or pulsed mode. When bypassed, built- in electronics behaves as an open circuit allowing direct control of the LED source.
LTCLHP | instruction manual 2.3 How to replace the LTSCHP module When you receive LTSCHP module, in the package you will find the following items: LED support (gray color) Power cable LTSCHP module LED centering tool Rear part (red color) to easily position and center LED1W-x light source...
Page 7
LTCLHP | instruction manual 2.3.1 Spacers selection and placement The number and type of spacers to place in your LTCLHP varies for each part number, depending on LED color and lens type (as shown below). When replacing a no more operational LTSCHP module or LED source, make sure to preserve the same spacers configuration of your LTCLHP unit.
Page 8
LTCLHP | instruction manual 2.3.2 Assembling instructions Follow these steps to properly assemble the LTSCHP module. Apply a small amount of thermal Position LED1W such that the black Insert LED centering tool, Now the LED1W is correctly grease on top of the LED support; and red cables can be inserted in one dowel pin at a time.
LTCLHP | instruction manual 2.4 How to replace the LED1W source When you receive LED1W source, in the package you will find the following items: LED centering tool allows LED1W: LED source to easily position and center component LED1W light source. LED1W source 2.4.1 Replacement instructions Follow these steps to properly replace LED1W source.
LTCLHP | instruction manual 3. CE Conformity Opto Engineering declares the products of the LTCLHP and LTSCHP series compliant with the provisions of the Community Directive 2004/108/CE EN 61326-1 (measuring devices and control laboratory) including all applicable amendments, and that all standards and/or technical...
Page 11
Contact us EUROPE UNITED STATES Opto Engineering Opto Engineering Opto Engineering Europe headquarters Germany Circonvallazione Sud, 15 Agnes-Pockels-Bogen, 1 11261 Richmond Ave 46100 Mantova, IT 80992 München, DE Ste G-108 - Houston, TX 77082 phone: +39 0376 699111 phone: +49 0 89 18930918 phone: +1 832 2129391 contact@opto-engineering.com...