Table 3 Requirements For Threaded Rods - ABB HT563116 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing
2.3.2 Fitting threaded rods
Figure 10: Inserting the threaded rods
1. Lightly oil the surfaces of the threaded rods (02) to be screwed in.
2. Screw the threaded rods into the bracket with the aid of locknuts (01).
3. Remove nuts (01) again.
Requirements for the threaded rods
Figure 11: Requirements for threaded rods
Product Diameter
Threaded rod
[mm]
A130 Ø 16 / M16
A135 Ø 20 / M20
A140 Ø 24 / M24
A145 Ø 30 / M30
Table 3: Requirements for threaded rods
Fixing material scope of delivery
The threaded rods and nuts for fastening the turbocharger on the bracket are not included in
the ABB Turbo Systems scope of delivery. These parts depend on the version of the engine-
side bracket.
The clamping nuts are included in the ABB Turbo Systems scope of delivery.
© Copyright 2015 ABB. All rights reserved.
Material Thread
DIN / ISO 898 length
(Part 1) L1 [mm]
10.9 / 12.9 ≥ 30
10.9 / 12.9 ≥ 30
10.9 / 12.9 ≥ 70
10.9 / 12.9 ≥ 80
HZTL4031_EN
Page 17 / 115
Length of threaded rod
Oil-cooled Water-cooled
L2 [mm] L2 [mm]
250
270
350 ... 360 410 ... 420
415 ... 425
Revision C February 2016
250
325
- -