Fig. 13: Inserting Threaded Rods Into The Bracket; Fig. 14: Requirements For Threaded Rods; Table 6: Requirements For Threaded Rods - ABB HT607772 Operation Manual

Operation Manual / TPS44-H.. - TPS52-H..
3 Removing and Installing / 3.3 Installing the turbocharger
3.3.2 Fitting threaded rods
Fig. 13: Inserting threaded rods into the bracket
1. Lightly oil the surfaces of the threaded rods (02) to be screwed in.
2. Screw the threaded rods into the bracket with the aid of locknuts (01).
3. Remove nuts (01) again.
Requirements for the threaded rods (02)
Fig. 14: Requirements for threaded rods
Product
Threaded rod
TPS44
TPS48
TPS52 Ø 20 / M20
Table 6: Requirements for threaded rods
Fastening material, scope of delivery
The threaded rods and nuts required for attaching the turbocharger to the bracket are not
included in the ABB scope of delivery. These parts depend on the version of the engine-side
bracket.
© Copyright 2021 ABB. All rights reserved.
Diameter Material
DIN / ISO 898
[mm]
Ø 16 / M16 10.9 / 12.9
Ø 16 / M16 10.9 / 12.9
10.9 / 12.9
Thread length
L1 [mm]
(Part 1)
≥ 30
≥ 30
≥ 30
HZTL4037_EN
Length of
threaded rod
L2 [mm]
150
170
195
Rev.G June 2021