Exploded View - Master MAC-24W User's Manual & Operating Instructions

Wall Mount Installation
Tools Needed:
Phillips screwdriver
Adjustable wrench (included in accessory bag)
1. Secure the wall mount to the desired location
with appropriate hardware (not provided).
2. Attach the bend pipe to the wall mount with
the provided bolts. Tighten the bolts.
3. Loosen the Phillips head set screw on the
lower supporter. Attach the motor to the bend
pipe by using the M12x40 screw, nut, and
washer to connect the lower supporter to the
upper supporter. Tighten the M12x40 screw
and the Phillips head set screw. Ensure the
screws are tight.
Operating Instructions
1. Confirm that the speed control knob is set to "O" off. Plug the cord into a standard 120 V A/C outlet.
2. Adjust to the desired speed setting.
Motor
Wall Mount
© 2022, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE

Exploded View

Rear Guard
Upper Support
M12 Nut Lower Support
The installer MUST be certain that
WARNING
the support bracket is mounted to a
minimum of a 2x4" stud, and that it is able to support
50 pounds continuously.
4. Remove the four (4) M6x10 Phillips head
flange screws from the motor.
5. Attach the rear guard to the motor with the
four (4) M6x10 Phillips head flange screws.
6. Attach the blade to the motor shaft by using
the allen wrench (in accessory bag). Make
sure the hex set screw is facing toward the
motor (hub down) when attaching.
7. Attach the front guard to the rear guard, using
the snap joint to tighten.
Set Screw Blades
M6x10 Flange Screw
M12x40 Screw
NOTE: The bolts and screws
are mix of metric and standard.
3
Front Guard
High Velocity Fan User's Manual