Connecting The Instrument; Fitting A Capillary; Switching The Compressor On And Off (For Test Purposes) - kruss BP50 User Manual

Operating the BP50
LED indicators
LED indicator
Run
Status
Cal
3.2

Connecting the instrument

!
It is essential to install the USB driver before you connect the instrument to the
computer for the first time ( LabDesk manual).
Connect the BP50 to a USB port on the computer.

3.3

Fitting a capillary

!
Wear disposable gloves so that the capillary does not become contaminated.
 Fit the capillary to the capillary holder on the BP50 using slight pressure.
3.4

Switching the compressor on and off (for test purposes)

The compressor can be switched on to check the generation and detection of
bubbles.
Press the

The compressor will start. The instrument will wait for measurable bubbles.
 Immerse the capillary in the liquid.
The Status
detected.
Switching off
 Press the
Blue, continuous. Data being transmitted to LabDesk

(during a measurement or calibration via LabDesk).
Green, flashing: The unit is waiting for measurable

bubbles.
Green, continuous: The unit has detected measurable

bubbles.
Red, continuous: Firmware update mode

( Chapter 5)
Blue, continuous: Calibration has been started via the

BP50 or via LabDesk
key.
indicator will illuminate continuously when measurable bubbles are
key once more.
Meaning
page 9