Table of Contents
Advertisement
8600 Installation Manual
WARNING
Failure to observe the information in this manual may result in personal injury or damage to
the equipment. To reduce the risk of injury to persons, use this operator with single or
double pedestrian swinging doors only.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
AVOIDANCE OF ELECTRIC SHOCK, INJURY, FIRE OR MALFUNCTIONS
Please read these instructions carefully before installing the door operator. We are not responsible for
any loss or damage if these precautions are not followed. These instructions should be followed to
avoid the possibility of injury and damage due to wrong installation or adjustment.
During maintenance and installation, the power to the control unit should be OFF.
Please use the correct power supply - Power Acceptance 90V-250V DC-50/60 Hz.
Make sure that the operator is grounded or connected to earth! The coating of the operator is made of
an electrically conductive metallic material which will easily induce electrical conduction. Make sure
the ground or earth wire is connected.
The operator housing is not completely sealed, therefore it should be noted that excessive moisture or
a corrosive atmosphere could destroy the electronic components contained within.
Do not remove screws and bolts from the structure of the Control Unit or Motor Gear Box. Do not
intend to open, repair, or alter any part of the operator unit. Failure to comply will result in loss of
warranty.
Installation and maintenance of this product can be performed by trained and authorized personnel
only.
Before switching ON the power supply, make sure that no objects obstruct the travel of the automatic
doors.
NATIONAL WIRING REGULATIONS AND STANDARDS MUST BE CONFORMED TO.
Follow all indicated instructions as improper installation could cause severe damage.
Correct equipment must be used in order to reach overhead area for installation and service.
KEEP FINGERS AND CLOTHING CLEAR OF ALL MOVING PARTS.
Please keep these instructions
36 MONTHS FROM SHIPMENT. WARRANTY VOID IF REPAIR IS ATTEMPTED TO MOTOR GEAR OR
WARRANTY
CONTROL ASSEMBLY.
2
Advertisement
Table of Contents
