Advertisement
Keep children and unauthorised persons away from the working area.
DO NOT hold unsecured work in your hand.
Avoid unintentional starting and ensure the lock on button is disengaged before use.
DO NOT force the hammer drill to achieve a task it was not designed to perform.
DO NOT operate the hammer drill in explosive atmospheres or where there are flammable liquids, gasses or dust.
DO NOT carry the hammer drill with your finger on the power switch, or leave the hammer drill running whilst unattended.
DO NOT abuse the power cord. Never use the cord for carrying, pulling or unplugging the hammer drill.
Keep the power cord away from heat, oil, sharp edges or moving parts.
DO NOT operate the hammer drill if any parts are missing or the hammer drill is damaged as this may cause failure and/or possible
personal injury.
Limit the exposure time by taking frequent rest periods. Vibration caused by hammer action may be harmful to your hands and arms.
When operating the hammer drill outdoors use an extension cable that is clearly marked for outdoor use.
Work only in daylight or good artificial light.
Keep handles and grasping surfaces dry, clean and free from oil and grease.
DO NOT allow the hammer drill to get wet.
DO NOT use in damp or wet locations.
DO NOT use in the rain or if there is a risk of lightning.
WARNING! If working in a damp location is unavoidable a residual current device (RCD) MUST be used.
DO NOT allow familiarity gained from frequent use of the hammer drill to let you become complacent and begin to ignore tool safety
principles.
When not in use, switch the hammer drill off, remove plug from power supply, clean the hammer drill and store in safe, dry, childproof
location.
1.3.
USING LONG DRILL BIT SAFETY
DO NOT operate at a higher speed than the maximum speed rating of the drill bit.
Always start drilling at low speed and with the drill bit tip in contact with the workpiece.
Apply pressure only in direct line with the drill bit.
DO NOT apply excessive pressure.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
750W Hammer drill with variable speed and reverse controls. Suitable for driving and removing screws. Hammer action allows up to Ø13mm
capacity in masonry. Features high quality Ø13mm chuck, textured grip handle and is supplied with adjustable side handle, 2m cable and
3-pin plug.
3. SPECIFICATION
Model No: ..............................................................SD750.V2
Chuck Size: ............................................................... Ø13mm
Drilling Capacities:
Wood: ....................................................................... Ø25mm
Steel:........................................................................... Ø8mm
Masonry: ................................................................... Ø13mm
Hammer Action: ................................................. 0-48000bpm
Motor Power:.................................................................750W
No-Load Speed: ....................................................0-3100rpm
Supply: ....................................................................220-240V
Vibration: ................................................................ 16.33m/s²
Uncertainty: ................................................................ 1.5m/s²
4. OPERATION
© Jack Sealey Limited
fi g.1
Original Language Version
fi g.2
fi g.4
SD750.V2 Issue 1 24/03/22
fi g.3
Advertisement
