HIKOKI DH 14DSL Handling Instructions Manual

HIKOKI DH 14DSL Handling Instructions Manual

Cordless rotary hammer

Advertisement

Quick Links

DH 14DSL ∙ DH 18DSL
DH14DSL
Handling instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DH 14DSL and is the answer not in the manual?

Questions and answers

Summary of Contents for HIKOKI DH 14DSL

  • Page 1 DH 14DSL ∙ DH 18DSL DH14DSL Handling instructions...
  • Page 2: General Power Tool Safety Warnings

    power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on.
  • Page 3: Cordless Rotary Hammer Safety Warnings

    c) When battery pack is not in use, keep it away 10. Do not touch the bit during or immediately after from other metal objects, like paper clips, coins, operation. The bit becomes very hot during operation keys, nails, screws or other small metal objects, and could cause serious burns.
  • Page 4: Regarding Lithium-Ion Battery Transportation

    1. When the battery power remaining runs out, the motor REGARDING LITHIUM-ION BATTERY stops. TRANSPORTATION In such a case, charge it up immediately. 2. If the tool is overloaded, the motor may stop. In this When transporting a lithium-ion battery, please observe the case, release the switch of tool and eliminate causes of following precautions.
  • Page 5: Standard Accessories

    Weight 2.1 kg 2.2 kg NOTE CAUTION Due to HiKOKI’s continuing program of research and Do not use the electrical cord if damaged. Have it development, the specifi cations herein are subject to repaired immediately. change without prior notice. When charging the battery from a DC 12V in-car power source (UC18YML2) ○...
  • Page 6 3. Charging <UC18YFSL, UC18YML2> When inserting a battery in the charger, the pilot lamp will light up continuously in red. When the battery becomes fully recharged, the pilot lamp will blink in red (At 1-second intervals). (See Table 1-a) ● Pilot lamp indication Fig.
  • Page 7 Table 1-b Indications of the charge indicator lamp Lights for 0.5 seconds. Does not light for Before Blinks 0.5 seconds. (off for 0.5 seconds) Plugged into power source charging (red) Lights for 0.5 seconds. Does not light for Blinks 1 second. (off for 1 second) Battery capacity at less than 50% (blue) While...
  • Page 8: Mounting And Operation

    Selecting the operating mode When replacing the carbon brush with a new one, be Adjusting the drilling depth sure to use the HiKOKI Carbon Brush Code No. 999100. Selecting the Save/Power mode 5. Replacing carbon brushes (Fig. 13) Take out the carbon brush by fi rst removing the brush...
  • Page 9 Prolonged storage (3 months or more) of batteries with Important notice on the batteries for the HiKOKI a low charge may result in performance deterioration, cordless power tools signifi cantly reducing battery usage time or rendering Please always use one of our designated genuine the batteries incapable of holding a charge.
  • Page 10 <UC18YML2> <UC18YFSL> <UC18YSL3>...
  • Page 12 Pm: 1500 /min Sm: 750 /min ⓐ ⓑ 3 mm 9.5 mm ⓒ...
  • Page 14 306370 971787 306885 1: 303617 944477 2: 303618 A: 303619 B: 303620 303332 303046 981122 303623 321814...
  • Page 15 324548 303709 999100 18V (Li-ion) 329897 14.4V (Li-ion) UC18YFSL (14.4V - 18V) UC18YML2 (14.4V - 18V) UC18YSL3 (14.4V – 18V) 337088 336471 337114...
  • Page 16 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99708811 G Printed in China...

This manual is also suitable for:

Dh 18dsl

Table of Contents