Carrying power tools with your fi nger on the switch GENERAL POWER TOOL SAFETY or energising power tools that have the switch on WARNINGS invites accidents. d) Remove any adjusting key or wrench before WARNING turning the power tool on. Read all safety warnings and all instructions.
c) When battery pack is not in use, keep it away 11. Always hold the body handle and side handle of the from other metal objects, like paper clips, coins, power tool fi rmly. Otherwise the counterforce produced keys, nails, screws or other small metal objects, may result in inaccurate and even dangerous operation.
WARNING REGARDING LITHIUM-ION BATTERY In order to prevent any battery leakage, heat generation, TRANSPORTATION smoke emission, explosion and ignition beforehand, please be sure to heed the following precautions. When transporting a lithium-ion battery, please observe the 1. Make sure that swarf and dust do not collect on the following precautions.
The specifi cations of this machine are listed in the Table on Full-load impact rate page 15. φ NOTE Drilling diameter, max. Due to HiKOKI’s continuing program of research and Weight* development, the specifi cations herein are subject to (According to EPTA-Procedure 01/2014) change without prior notice. Concrete...
Page 10
Table 1 Indications of the pilot lamp Lights for 0.5 seconds. Does not light for 0.5 Before Blinks seconds. (off for 0.5 seconds) charging Lights continuously While charging Lights Lights for 0.5 seconds. Does not light for 0.5 Charging Blinks seconds.
Page 11
16, 17 Tool bit biting into material For detailed information regarding each tool, contact a Impact against nails, metal or other hard objects HiKOKI authorized service center. Tasks involving prying or any excess application of pressure, etc. SELECT OPERATION MODE Also, other causes include any combination of the aforementioned.
ABOUT THE PROTECTION LUBRICATION FUNCTION Low viscosity grease is applied to this rotary hammer so that it can be used for a long period without replacing the This tool has a built-in protection circuit for preventing grease. Please contact the nearest service center for grease damage to the unit in the event of an abnormality.
Page 13
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed. Important notice on the batteries for the HiKOKI cordless power tools Please always use one of our designated genuine batteries. We cannot guarantee the safety and...
TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. 1. Power tool Symptom Possible cause Remedy Tool doesn’t run No remaining battery power Charge the battery.
Page 15
DH18DPA 18 V 0–1080 /min 0–5500 /min 18 mm φ max 13 mm φ max 18 mm φ max 2.1–2.7 kg BSL1850C UC18YFSL DH18DPA (2JA) (NNP) – – – (NN) – – – –...
Need help?
Do you have a question about the DH 18DPA and is the answer not in the manual?
Questions and answers