Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (82) until the treadmill is in the position shown.
2. Remove the Latch Knob (110) from the Latch Pin (114).
Make sure that the Latch Pin Collar (112) and the Spring
(111) are on the Latch Pin (114) as shown. Insert the
Latch Pin into the Storage Latch (77).
Tighten the Latch Knob (110) back onto the Latch Pin
(114).
3. See drawing 3a. Press a Handrail Insert (102) into the
lower end of a Handrail (85). Hold an Extension Leg
(103) against the lower end of the Handrail. Insert a
Handrail Bolt (78) with a Handrail Washer (36) into the
Extension Leg and thread the Handrail Bolt three or
four turns into the Handrail. Notice the angle of the
Handrail and insert the Handrail Bolt and Washer at the
same angle (see drawing 3b).
Attach a Handrail Insert (102) and an Extension Leg
(103) to the other Handrail (85) in the same way.
All manuals and user guides at all-guides.com
and rubber mallet
6
.
1
2
110
77
3a
85
102
103
36
78
82
111
112
114
3b
85
103
36
78
Advertisement
Table of Contents
