Spk.setting Page - JVC XV-SA600BK Instructions Manual

Changing the initial settings

SPK.SETTING page

SPK.SETTING
MODE 5.1 CH.
SIZE
DELAY
LEVEL
SELECT USE 5∞ TO SELECT, USE ENTER TO CONFIRM
TO EXET, PRESS CHOICE.
ENTER
Menu items
MODE
You can select the speaker
configuration type according to
your speaker systems. Normally,
set to "5.1 CH."
SIZE
You can set the speaker sizes
according to your speakers.
DELAY
You can set the speaker delay time
according to your speakers.
LEVEL
You can set the speaker output level
according to your speakers.
62
This setting allows you to select desired options concerning with the speakers.
Setting options
• 5.1 CH.
When you connect to a 5.1-channel
amplifier and use the front, rear,
center and sub-woofer speakers.
• EXPERT
When you want to make fine tuning
to match your speakers. The SIZE,
DELAY, and LEVEL setting items are
available.
See page 64 for details about the
speaker size setting.
See page 64 for details about the
speaker delay time setting.
See page 65 for details about the
speaker output level setting.
Notes/examples
• When selecting "5.1 CH.," set
"ANALOG OUT" to "MULTI
CHANNEL" in the "AUDIO"
preference display (see page 61).
• The Dolby Digital LEF (Low
Frequency Effect) signal is always
fed from the SUBWOOFER jack on
the rear panel of the unit regardless
of speaker setting.
• If you connect the unit's digital
output to an external Dolby Digital
or DTS decoder (and set "DIGITAL
AUDIO OUTPUT" to "STREAM/
PCM" in the "AUDIO" preference
display), the speaker settings shown
left is not effective. Make the
speaker settings of the external
decoder properly.
(SIZE display)
SIZE
FRONT SPEAKER LARGE
CENTER SPEAKER
SMALL
REAR SPEAKER SMALL
BASS REDIRECT
SUB WOOFER
RETURN
SELECT USE 5∞ TO SELECT, USE ENTER TO CONFIRM
TO EXET, PRESS CHOICE.
ENTER
(DELAY display)
DELAY
CENTER SPEAKER 0.0m/ 0ft
REAR SPEAKER 0.0m/ 0ft
RETURN
SELECT
USE 5∞ TO SELECT, USE ENTER TO CONFIRM
ENTER TO EXET, PRESS CHOICE.
(LEVEL display)
LEVEL
FRONT SPEAKER
0dB
CENTER SPEAKER 0dB
REAR SPEAKER 0dB
SUB WOOFER
0dB
TEST TONE OFF
RETURN
SELECT USE 5∞ TO SELECT, USE ENTER TO CONFIRM
TO EXET, PRESS CHOICE.
ENTER