Chamberlain SLA230E Manual page 7

Remote light
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 7
Start by Reading These Important Safety Rules
These safety alert symbols mean WARNING – a personal safety or property damage
instruction. Read these instructions carefully.
Failure to comply with the following instructions may result in serious personal injury or
property damage.
Installation and wiring must be in compli-
ance with your local building and electri-
cal codes. This is a class 2 double
insulated product, connection to
earth is not required or provided.
This unit should not be installed in a
damp or wet space.
This product is provided with a trans-
former and power supply cord of special
design which, if damaged, MUST be
replaced by a transformer from your
local Chamberlain distributor and fit-
ted by a specialist.
Use as prescribed
LED lamp with low voltage and separate power supply unit for use in garage, work shop, hallway,
cellar, entrance, protected house wall or similar application with provided mains socket. A sensor
in the lamp registers movement and switches lamp on for the pre-set time. The lamp can be
operated via remote control due to built-in radio receiver.
A different or surplus usage is not in accordance with prescribed use.
Delivery contents
Model SLA230E
• Power supply unit with plug and cable
• Lamp with built-in receiver
• Mounting material, see illustrations
• Instruction manual
Product overview
• LED lamp with reflector (1)
• Joint with lock nut (2)
• Covering for receiver (3)
• LED for movement sensor (4)
• Sensor for movement (5)
• Power supply for lamp (6)
• Power supply unit with wire (7)
• Screws (8)
• Plugs (9)
• Cable clamps (nail clamps) (10)
• Switch: range of movement sensor (11)
• Switch: light delay (12)
WARNING
3.0
3.0
3.0
The lamp must be installed out of the
reach of children.
The lamp must not be installed, con-
nected or operated in potentially
explosive rooms.
The wire of the mains socket must not
be shortened or extended.
The minimum distance to combustible
objects must be at least 1m.
• LED for setting of new remote controls (13)
• Learn button for radio remote controls (14)
• Wall mounting bore (15)
• Wall mounting slot (16)
• Seal (17)
1-en
3.0

Advertisement

Table of Contents
loading

Table of Contents