Table of Contents
Advertisement
Changing Settings
On first power up from factory settings, the unit will enter set mode. Set Mode can also be
accessed after initial configuration by holding the settings button
pressing the increment touch button ↑.
In set mode press the settings button to move on to the next setting, select
between digits or increment
Hold the settings touch button
update the settings and return to Run Mode.
Text highlighted in red below shows what will appear on the display. Settings will typically be
displayed in the order below, though the available settings will vary depending on the
selected instrument.
A setting can be skipped by pressing settings
displayed.
Once all settings have been stepped through or skipped, the unit will return to
setting 1. The unit will remain in set mode until run mode is entered as described above.
Each mode has an independent set of settings and after the mode is selected, the set values
will be applied to that mode only. The exceptions to this are the input type (INPUT) which is
available in Frequency A and Frequency B mode only and set the input type for that channel,
and the lock (LOCKED) which locks the settings for all modes when set to YES.
The settings will be displayed and can be altered as follows:
1.
MODE
– Set frequency mode [Default A]
Press increment
FREQ A
= Frequency A
FREQ B
= Frequency B
A/B
= Ratio A/B
B/A
= Ratio B/A
Press settings
2.
7 DISP
– Set function of 7
Press increment
DIGIT
= Display is 7 digits (unsigned)
SIGN
= Display is 6 digits & sign
Press settings
↑
to modify the value.
and then with this held press increment
↑
to select from the below options.
or select
←
to move to the next setting.
th
display [Default DIGIT]
↑
to change between from the below options.
or select
←
to move to the next setting.
when either the title or the setting value is
11
and then with this held,
←
to move
↑
at any time to
Advertisement
Table of Contents
