Logitech 2000 MKIII Series User Manual page 18

Electronic Sensors and Rotary Encoders
Set input type (INPUT) to standard sensitivity (STD). The sensor/encoder can be supplied from
the Vs terminal, provided that the sensor is rated to operate at this voltage. The
sensor/encoder's 0V connection should be made to any of the common 0V terminals, along
with the cable screen if this is not connected to 0V at the sensor/encoder end. The signal can
be connected to either IPa or IPb for single channel operation.
Vs 0V NC NC NC NC NC 0V IPa 0V IPb
0V
V+
Screen
Signal
Reed Switch
Set input type (INPUT) to reed switch (REED). Connect one switch terminal to the supply
voltage (Vs) and the other to the input terminal IPa or IPb for single channel operation. The
maximum frequency is limited to 200Hz. Adjust the sensitivity until the correct value is
displayed at the maximum frequency of operation.
Vs 0V NC NC NC NC NC 0V IPa 0V IPb
18