Memoskop C-E - Siemens SIREMOBIL Compact Service Instructions Manual

6 - 14

Memoskop C-E

NOTE
•
Replace the Memoskop C-E.
The attachment screws are on the underside of the storage device.
•
Configure the Memoskop C-E for the correct video frequency and the number of
monitors present.
Refer to Chapter 5 "Memoskop C-E without Keyboard, Emulation ...", "Configuring the
Video frequency" and "MEMOSKOP-Configuration for the number of existing monitors".
•
Configure the following parameters in Technical Setup for the Memoskop:
3 Number of monitors
4 Hardcopy setup
5 Edge 1 coef set
6 Edge 2 coef set
7 Motion detection setup
10 Date / Time format
12 Keyboard
13 Language
15 Display of realtime clock Configure Yes. Configure No only upon customer request.
16 Display of rotated images Configure Yes.
17 Monitor zoom
18 Monitor split
19 Monitor text
20 Maximum image number Configure 100.
•
Configure the following parameters in User setup for Memoskop:
A Operating mode parameters Change the programmed parameters only on the cus-
B Video recorder output
C Documentation
D Text monitor
SIREMOBIL Compact
System Manual
Replacing boards / replacing components
Read and record the parameters for Memoskop C-E if you are able
to select User setup. After replacing the Memoskop, configure the
Memoskop C-E according to the parameters noted.
Configure 1 for SIREMOBIL Compact with1 monitor.
Configure 2 for SIREMOBIL Compact with 2 monitors.
Check whether 5500 is programmed in "4 Max Hardcopy
time". If not, program this value.
Check whether 3 is programmed, if not, program this value.
Check whether 8 is programmed, If not, program this value.
Check whether the following are programmed MD1: Thresh-
old 100 and at MD2: Threshold 120.
If not, program these values.
Set to country-specific format.
Set to the keyboard layout being used.
Set for the language of the country.
Configure No.
Configure Yes for SIREMOBIL Compact with 1 monitor.
Configure No for SIREMOBIL Compact with 2 monitors.
Configure Yes.
tomer's request.
Configure to Monitor A.
For SIREMOBIL Compact with 1 monitor:
Configure to monitor A.
For SIREMOBIL Compact with 2 monitors:
Configure to monitor B.
For SIREMOBIL Compact with 1 monitor:
Configure to monitor A.
For SIREMOBIL Compact with 2 monitors:
Configure to both monitors.
Register 5 RXR2-130.061.02
Rev. 03
Page 14 of 18
10.03 CS PS 24
6
Siemens AG
Medical Engineering