Table of Contents
Advertisement
36
EN
EJECT Switch
Power lamp
Power Switch
LCD Monitor in Retracted Position
Battery pack remaining power indicator
Tape counter
Recording mode indicator
S ET
SP
M 1 : 23 : 45
TAPE END
VOLUNE
LCD monitor/viewfinder
indications
Rewind (2) Button
Fast-Forward (3)
Button
Play/Pause (4/6) Button
Stop (5) Button
Tape running
indicator
AT
4 : Playback
3 : Fast-Forward/
Forward Search
2 : Rewind/Reverse
Search
6 : Still Playback
PLAYBACK
1
LOAD A CASSETTE
First open the LCD monitor to an angle of over 60
degrees. Slide EJECT to open the cassette holder, then
insert the cassette with the label facing out. Press the
Close button to ensure the holder is closed and
locked.
2
SELECT MODE
Make sure the LCD monitor is fully open, then set the
Power Switch to "PLAY". The power lamp lights.
3
PLAY BACK
Press 4/6. The playback picture appears.
4
STOP PLAYBACK
Press 5.
Rewind or Fast-Forward the tape
Press 2 to rewind, or 3 to fast-forward the tape during
Stop mode.
NOTES:
The camcorder shuts off automatically after about 5
minutes in Stop mode. To turn on again, set the Power
Switch to "OFF", then to "PLAY".
When the Power Switch is set to "PLAY" and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power.
The playback picture can also be viewed in the
viewfinder (with the LCD monitor shut) or on a
connected TV (
pg. 40, 41). Camcorder operation is
the same as described in this section.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
If a blank portion on the tape is played back, the screen
may become black. This is not a malfunction.
Basic Playback
Hide quick links:
Advertisement
Table of Contents
