Table of Contents
Advertisement
s Set the "Amp Assign" Mode According to the Speaker Layout
The signals output from the AVR-2310CI's SURR. BACK/AMP ASSIGN speaker terminals can be
switched to signals of the surround mode being used (vpage 28 "Amp Assign").
Amp assign mode
SURR. BACK/AMP ASSIGN
(vpage 28)
Speaker connections
Surround back
Normal
speakers
Surround back
speakers
b Connect to the "L" speaker
Normal
terminal.
b Set "S.Back" (vpage 29)
to "1spkr".
Not connected
b Set the "S.Back" setting
Normal
(vpage 29) to "None" .
Front Height
Front Height
speakers
Front A or B
speakers
Front A Bi-Amp
b For connections, see
or
"About bi-amp connections"
Front B Bi-Amp
(vpage 13).
ZONE2
ZONE2
(Default)
speakers
Installing/Setting the Speakers
Connecting the Speakers
Subwoofer with
built-in amplifier
Example of speaker installation
(7.1)
(6.1)
(5.1)
Protection circuit
(7.1)
If the core wires touch the rear panel and the screws
etc., or the ± sides touch each other, the protection
circuit will be activated and the power indicator will
flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned off,
(5.1)
after the power supply cord is withdrawn, please
confirm that speaker cable and input cable are
MAIN ZONE
ZONE2
connected.
Also, if replaying large sound levels by using
a speaker having an impedance less than that
(2)
(5.1)
Front speakers
Front speakers
A
B
(L)
(R)
(L)
(R)
w
q
w
q
w
q
w
q
For connections of the SURR. BACK/AMP
ASSIGN speaker terminals, see "Amp Assign"
(vpage 28).
specified (eg, 4 Ω/ohms), the temperature will rise,
and the protection circuit might be activated. The
power supply will go into the standby state, and the
power indicator will flash red at 2 second intervals.
In this case, please switch off the power supply, and
wait until the AVR-2310CI has cooled down, and the
surrounding ventilation is good.
Even if there are no problems with the surrounding
ventilation and connections, in the event of the
protection circuit becoming activated, due to
thinking that the AVR-2310CI has failed, please
contact DENON Service center after switching off.
ENGLISH
Center
Surround
speaker
speakers
(L)
(R)
w
q
w
q w
q
2
Advertisement
Table of Contents
