Stop Recording - JVC GR-DVM50 Instructions Manual

START/STOP Button
Tape remaining time indicator
25 min
(Now calculating)
4
NOTES:
The image will not appear simultaneously in the LCD
monitor and the viewfinder. No image appears on the
LCD monitor when the viewfinder is pulled out. It is not
possible to shoot using both LCD monitor and
viewfinder.
The cassette holder cannot be opened unless a power
supply is attached.
There may be a delay after you open the cassette cover
until the holder opens. Do not use force.
The indicated tape remaining time is approximate.
The time required to calculate and to display the
remaining tape length, and the accuracy of the calcula-
tion, may vary according to the type of tape used.
"TAPE END" appears when the tape reaches its end, and
min
the power goes off automatically if left in this condition
for 5 minutes. "TAPE END" also appears when a cassette
whose tape is already at its end is loaded.
90 min
If the Record-Standby mode continues for 5 minutes, the
camcorder's power shuts off automatically. To turn the
89 min
camcorder on again, push back and pull out the
viewfinder again or close and re-open the LCD monitor.
When a blank portion is left between recorded scenes
3 min on the tape, the time code is interrupted and errors may
occur when editing the tape. Continue recording from
where you stop so that there are no gaps by following
2 min
"Recording from the middle of a tape" (
(Blinking)
During recording, sound is not heard from the speaker. If
you want to hear the sound, connect optional head-
1 min
phones to the headphones connector. The sound
(Blinking)
volume at this point is the same as the level it was
adjusted during playback.
0 min
To turn the tally lamp off during recording, refer to
(Blinking)
pgs. 28 and 30.

STOP RECORDING

Press START/STOP again to stop recording.
•The camcorder re-enters the Record-Standby mode.
17
EN
pg. 21).