Table of Contents
Advertisement
YPP6830 Pulse Input Rate/Totalizer
K-Factor Value (factr)
Enter the K-factor value. This value is entered in Pulses/Unit as defined by the K-
Factor Units parameter. Most flowmeter manufacturers provide this information with
the device.
Display Units (Units)
The Units menu is used to select the display rate units and time (example: Gal/s) and
the display units for total and grand total.
Important Programming Note:
The units selected in this menu are the desired display units only. The units de-
fined by the k-factor of a flow meter are entered in the K-Factor menu as part of
the Factor Unit menu programming. See K-Factor Units (FuNiT) on page 38 for
details.
This allows the display units to be different than the units defined by the flow me-
ter, or be changed easily after initial programming. Unit conversions for rates and
totals are performed automatically by the meter. See Automatic Unit Conversions
on page 45 for details.
39
Instruction Manual
Advertisement
Table of Contents
