Advertisement
Quick Links
OPERATION INSTRUCTIONS
60cm White Slide Out Rangehood
Model No. MR60WSOUT
GSM Retail Australia Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: Australia 1300 373 199
V2 July 2022
For Warranty and technical queries: New Zealand 0800 764 912
www.mistral.com.au
Advertisement
Related Manuals for Mistral MR60WSOUT
Summary of Contents for Mistral MR60WSOUT
- Page 1 OPERATION INSTRUCTIONS 60cm White Slide Out Rangehood Model No. MR60WSOUT GSM Retail Australia Pty Ltd ABN: 53 007 582 475 For Warranty and technical queries: Australia 1300 373 199 V2 July 2022 For Warranty and technical queries: New Zealand 0800 764 912...
- Page 2 Th ank you Thank you for choosing Mistral Appliances. All Mistral appliances carry a 2 year In Home warranty be sure to retain your Installation and user manual and receipt. For all warranty and technical queries please contact Australia 1300 373 199...
- Page 3 Start using your appliance ......... 5-6 Maintenance ............7-8 Warranty .............. 9-10 GSM Retail Australia Pty Ltd ABN: 53 007 582 475 For Warranty and technical queries: Australia 1300 373 199 For Warranty and technical queries: New Zealand 0800 764 912 www.mistral.com.au...
- Page 4 Safety Instructions This manual explains the proper installation and use of your range hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. In case of failure, only the Authorised Technical Service may repair this range hood.
- Page 5 Safety Instruction Never to do: Always to do: • This range hood cannot be installed for outdoor use. • Attention should be given to ensure that • It is prohibited to fit the range hood over a solid any applicable regulations concerning discharge of exhaust air are fulfilled.
- Page 6 Product Description Accessories bag Description Picture Installation & User Manual Metal plate L bracket Outlet( diameter 120mm) Dry wall anchors plugs Screw (M4x10mm) Screw(ST4x30mm) Screw (ST3x12mm)* Washer* Screw (M4x35mm)* *Used in installation method B Component list: Technical data: 1. L bracket(used installation A method) 2.
- Page 7 Operation Mode Your range hood can only be operated in ducting mode (Air Extraction). Air Extraction For air extraction mode, a ducting kit is required, the air is drawn in and cleaned by the grease filters and directed outside. Ducting must be vented to outside atmosphere.
- Page 8 Installation Installation: Warning: Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating plate inside the range hood. When installing the range hood, make sure you adhere to the minimum and maximum distances from the range hood base to the cooktop hob surface.
- Page 9 A: Install against wall Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line where the hood base will be. NOTE: The distance from the horizontal line to an electrical cooktop underneath must be minimum of 600mm &...
- Page 10 Fit the outlet and flexible exhaust pipe on top of range hood body. Hang on the range hood, fasten 2pcs Screw(ST4x30mm) and L bracket onto two higher holes(with distance to horizontal line 516mm), and then fasten 2pcs Screw (M4x10mm) and L bracket onto body. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards B: Install into cabinet...
- Page 11 Fit the outlet on top of range hood body. Install the range hood onto the bottom of cabinet board, fasten 6pcs Screw (M4x35mm) with washers. If gap is there between range hood back and cabinet end, fasten 2pcs Screw (ST3x12mm) and metal plate onto body to fill it. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards Installation of charcoal filters...
- Page 12 Start Using Your Range Rocker switch Rocker switch 1. Insert the power plug into the socket. 2. Push switch ① to" " , the lamp will be on; push switch ① to “0”, the lamp will be off. 3. Push the switch ② into “I、II”, the motor will be on “low、high” two speeds, push into “0”, the motor will be off.
- Page 13 Maintenance and cleaning GREASE MESH FILTERS Caution: The mesh filters can be cleaned by hand.Soak them • Before maintenance or cleaning is carried out, for about 3 minute in water with a mild detergent and the range hood should be disconnected from then brush it gently with a soft brush.
- Page 14 LED LIGHT ASSEMBLY REPLACEMENT Important: The light must be replaced by the manufacturer, its service agent or similarly qualified persons. Always switch electricity supply before carrying out any operations on the appliance. When handling the light, make sure it has completely cooled down before any direct contact to hands.
- Page 15 Consumer until the expiry of Two (2) year (Warranty Period) If . f within the Warranty Period a manufacturing defect is discovered in the Mistral product or it fails to perform to the Company’s specifications as a result of some defect in materials, components or workmanship (Defect) then the Company will, at its option, repair the Mistral product or supply a replacement Mistral product free of charge.
- Page 16 1.10 If you are required to transport the Mistral product to the Company or its service agent, you must ensure it is safely disconnected by a qualified tradesman and securely packed and insured. The Company does not accept any responsibility for loss or damage of the Mistral product prior to it being received by the Company or its service agent.