en Troubleshooting
Fault
All other error codes.
Malfunctions
Fault
The appliance is not work-
ing.
The programme does not
start.
58
Cause
Detergent dosage is too
high.
Malfunction
Cause
The mains plug of the power
cord is not plugged in.
The circuit breaker is faulty.
There has been a power cut.
You have not pressed Start/
Reload
.
Door is not closed.
Childproof lock is activated.
- Finish in + is activated.
Laundry is caught in the
door.
troubleshooting
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the compartment for manual
dosing (not for outdoor clothing,
sportswear or items stuffed with
down).
If intelligent dosing is activated, re-
▶
duce the "basic dosage"
→ Page 41.
If you dose manually, reduce the
▶
amount of detergent for the next
washing cycle with the same load.
Call the after-sales service.
▶
→ "Customer Service", Page 68
troubleshooting
Connect the appliance to the power
▶
supply.
Check the circuit breaker in the
▶
fuse box.
Check whether the lighting in your
▶
kitchen or other appliances are
working.
Press Start/Reload
▶
Close the door.
1.
Press Start/Reload
2.
programme.
→ "Deactivating the childproof
▶
lock", Page 40
Check whether - Finish in + is ac-
▶
tivated.
→ "Buttons", Page 24
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start/Reload
4.
programme.
.
to start the
to start the