JVC GR-AX1010U Instructions Manual page 29

B
K
BLACK FADER
Fades in/out to a black screen.
C
BLUE FADER
Fades in/out to a blue screen.
MOSAIC FADER
Gradually turns/returns the picture into/from a
mosaic pattern.
SHUTTER WIPE
A black screen moves in from the top and bottom,
closing over the image like a shutter, or a new
image pushes open the black screen vertically from
the center. *During Auto Select mode, the new
image wipes in over the old image, not a black
screen.
SLIDE WIPE
A black screen moves in from the left to gradually
cover the image, or a new image moves in from
right to left. *During Auto Select mode, the new
image wipes in over the old image, not a black
screen.
CORNER WIPE
A black screen starts in the lower left corner and
gradually fills the screen, or a new image starts in
the upper right corner and fills the black screen.
*During Auto Select mode, the new image wipes in
over the old image, not a black screen.
DISSOLVE
1
Press the RECORDING START/STOP button.
— Recording starts.
2
Press the RECORDING START/STOP button
again.
— Recording stops, and the Record–Standby
mode is engaged.
— Now the last scene is stored in memory.
Before the power turns off...
3
Press the RECORDING START/STOP button to
resume recording.
— The stored scene is gradually replaced by the
new scene being shot.
SCROLL WIPE (AUTO SELECT only)
A new image scrolls up onto the screen.
WINDOW WIPE (AUTO SELECT only)
A new image enters from the center and moves
towards the corners of the screen.
DOOR WIPE (AUTO SELECT only)
A new image opens like a door onto the screen.
— —
AUTO SELECT
Press RECORDING START/STOP to begin or end
recording, and 6 wipe-ins are automatically
generated, in the order shown below:
SLIDE WIPE
SCROLL WIPE
CORNER WIPE
WINDOW WIPE
DOOR WIPE
SHUTTER WIPE
1
Press the RECORDING START/STOP button.
— Recording starts.
2
Press the RECORDING START/STOP button
again.
— Recording stops and the Record-Standby
mode is engaged.
— Now the last scene is stored in memory.
Before the power turns off...
3
Press the RECORDING START/STOP button to
resume recording.
— The new scene gradually wipes in over the
stored scene.
— Repeat steps 2 and 3 as you like.
NOTES
(for Dissolve and Auto Select):
Turning off the camcorder will erase the scene
stored in memory. When a scene is erased from
memory, the symbol indication blinks.
The sound for the last recording's scene is not
stored in memory.
This mode indicator blinks unless an image is
stored in memory. In this case, shoot a scene first.
29
EN