Main Menu; Sub Menu - JVC GR-AX1010U Instructions Manual

MAIN MENU

Shift Zoom
Tele Macro
Gain UP
Color Filter
Tape Length
Title
Date/Time

SUB MENU

Tally
Interval Timer and
Rec. Time
JLIP ID NO.
NOTES:
When the video light's LIGHT ON/AUTO/OFF switch is set to "ON" or "AUTO", Auto Slow Shutter is
disabled.
When Auto Slow Shutter is activated, Auto Focus may not work properly.
OFF Disables the Shift Zoom function.
50x Magnifies wide-angle images to approximately 3.6 times the
original size, and enables zooming in the 18x – 50x range.
140x Magnifies wide-angle images to approximately 10 times the
original size, and allows zooming from 50x to 140x.
OFF Usually set to this position.
ON Usually the distance to a subject where the lens is in focus
depends on the zoom magnification. Unless there is a
distance more than 1m (3.3 ft.) to the subject, the lens is out of
focus at the maximum telephoto setting. When set to "ON",
you can shoot a subject as large as possible at a distance of
approx. 60 cm (2 ft.).
•Depending on the zoom position, the lens may go out of
focus.
AGC Allows you to record a subject in a dark environment. It
delivers a brighter, if slightly coarse, picture.
(Auto Slow Shutter) Combines AGC with electronic shutter
A
speed (1/30 to 1/60) for shooting under much darker
conditions. When shooting in poorly lit areas, or when
shooting a dark subject in dim lighting, the unit will
automatically enter the Auto Slow Shutter mode, reducing
the shutter speed to 1/30 sec. Although the resulting picture
will be similar to that obtained when using Strobe (
the image will be clear with less noise.
OFF Allows you to shoot dark scenes with no picture brightness
adjustment.
NOR For normal shooting with no color adjustment.
RED Gives recording a reddish tint.
BLUE Gives recording a bluish tint.
Allows you to set the tape length depending on the tape used (
Allows you to superimpose a preset title onto a scene (
Allows you to set the current date and time (
= Factory setting
ON The tally lamp comes on to signal the start of recording.
OFF The tally lamp remains off at all times.
These features allow you to set the parameters for Self-Timer
( pg. 34), Animation and Time-Lapse recording (
This number will be necessary in the future when connecting the
camcorder to a device such as a computer using the JLIP terminal.
The numbers range from 01 — 99.
31
EN
pg. 27),
pg. 12).
pg. 32).
pg. 11).
pg. 35).