Klarstein 10041143 Manual page 28

EN
28
Note: Never pour water into the internal water tank, which is located below the
ice basket. This water tank is not big enough. Non-observance can negatively
affect the ice-making process.
2. Switch on: When you insert the mains plug into the socket, the symbol
starts flashing. The current room temperature is displayed on the upper left
right side of the screen. For example, if [26 °C] is displayed there, it means that
the room temperature is 26 degrees Celsius. Press the ON/OFF button again
to start the unit. The water flows into the water tank to the standard level.
The compressor is then started and the ice cube production begins. At the
same time, the display
rotating display . The temperature display disappears. After a few minutes
of making ice cubes, the digital display flashes in the temperature display area
of the screen. For example, if [10 M] is displayed, it means that the ice cube
making process will be finished in 10 minutes.
3. When the ice cubes are dispensed, the symbol
water flows through the solenoid valve into the lower water tank and the
symbol is displayed. When the lower water tank is full, the symbol
out. The next ice cube making process begins. If there is no water in the water
tank, the symbol
the water tank. Then restart the appliance to make ice cubes. You also have
the option of filling the water tank directly and waiting 20 minutes for the
machine to restart.
Note: An ice cube making cycle takes 13 - 25 minutes, depending on the room
temperature. When you use the device for the first time, it may take a little
longer to make ice cubes, depending on the initial temperature of the water.
If the room temperature is high, the ice cube making process can take much
longer, but no longer than 35 minutes. If the ice cubes are not big enough
for you, press the + or - button during ice cube making to adjust the ice cube
making time. If you press the + button, the ice cube making time is increased
by one minute at a time. Pressing the - button decreases the ice cube making
time by one minute. The time can be increased or decreased by a maximum of
6 minutes. Your adjustment will be taken into account from the next ice cube
making cycle.
disappears from the screen and is replaced by the
remains lit. Switch off the machine and fill water into
flashes on the screen. The
goes