Electrolux EHH9967FSG User Manual page 9

Heat setting
4 - 7
8 - 9
10 - 14
4.3 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct heat
setting.
0 3 5
4.4 Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook.
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware automatically.
You can cook with the large cookware on
two cooking zones at the same time.
4.5 Bridge function
This function connects two cooking zones
and they operate as one.
You can use this function for cookware
larger than 260 mm.
First set the heat setting for one of the
cooking zones.
To activate the function: touch
set or change the heat setting touch one
of the control sensors.
To deactivate the function: touch
The cooking zones operate independently.
When you use only one cooking zone of
the pair we recommend that you use the
The hob deacti-
vates after
5 hours
4 hours
1.5 hour
8 10 14 P
. To
.
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
4.6 Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
Immediately touch the correct heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.
4.7 Power function
This function makes more power available
to the induction cooking zones. The
function can be activated for the induction
cooking zone only for a limited period of
time. After this time the induction cooking
zone automatically sets back to the
highest heat setting.
Refer to "Technical
information" chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: change the
heat setting.
4.8 Chef function
This function activates all cooking zones
and automatically activates for all of them
the Bridge function. The function sets the
same heat setting as the one you set the
last time.
For the first activation the heat setting of
the left pair of zones is set to
middle pair is set to
is set to .
To activate the function: touch
indicator comes on. All cooking zones
ENGLISH
comes on).
comes on.
comes on.
, the
and the right pair
. The
9