Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Owon SLC628
Summary of Contents for Owon SLC628
- Page 1 SLC628 In-wall Touch Switch Quick Start Guide...
- Page 2 Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the In-wall Touch Switch and other property. Read all the safety notices below before using the In-wall Touch Switch. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light.
- Page 3 Technical Specifications Wireless Connectivity ZigBee • 2.4GHz IEEE 802.15.4 ZigBee Profile • ZigBee 3.0 • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m / RF Characteristics 30m (Open area) • Internal PCB Antenna Physical Specifications Button • Touch Screen Operating Voltage • 100~240 Vac 50/60 Hz Power consumption • <...
- Page 4 Weight • 114 g • In- wall mounting Mounting Type • EU standard or CN standard • EU: ROSH Certificate • CN: CE, ROSH...
- Page 5 Welcome The In-wall Touch Switch allows you to remotely control your lighting or even apply schedules for automatic switching. This guide will provide you with an overview of the product and help you get through the initial setup and installation. Features: •...
- Page 6 Installation Important safety information! • The In-wall Switch must be installed and serviced only by qualified electrical personnel. • Do not touch the terminals of the device during the testing. • Turn off all power supplying this equipment before installing. • Make sure that the power supply is off before connecting or disconnecting it to the auxiliary device.
- Page 7 Get to know your device ON/OFF switch and LED indicator Reset: Press one of the on/off button(s) 3 times and hold at the third time for 6 seconds until the LED indicator start flashing to restore the Switch. LED indicator The LED status gives the following information: LED status What it means...
- Page 8 Configure Network 4.1 To get started, you will need: • A Zigbee Gateway. • A mobile phone with a mobile APP installed. 4.2 Adding to the gateway's network 1. Set your gateway to permit joining (see your gateway's manual). 2. Power on the in-wall switch and the LED indicator will start flashing (reset the switch if not), indicating it is ready to join the gateway's network for 2 minutes.
Need help?
Do you have a question about the SLC628 and is the answer not in the manual?
Questions and answers