Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Owon SLC600-S
Summary of Contents for Owon SLC600-S
- Page 1 SLC600-S Scene Switch Quick Start Guide...
-
Page 2: Safety Handling
Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the Scene Switch and other property. Read all the safety notices below before using the Scene Switch. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light. -
Page 3: Technical Specifications
Technical Specifications Wireless Connectivity ZigBee • 2.4GHz IEEE 802.15.4 ZigBee Profile • ZigBee 3.0 • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m / RF Characteristics • Internal PCB Antenna • TX Power: 19DB Physical Specifications Operating Voltage • 100~250 Vac 50/60 Hz Flame Rating • V0 Power consumption • <... - Page 4 • 145g Weight • In-wall mounting Mounting Type • CN standard...
- Page 5 Welcome The Scene Switch SLC600-S is designed to trigger your scenes and automate your home. You can connect your devices together via your gateway and activate them via your scene settings. This guide will provide you with an overview of the product and help you get through the initial setup.
-
Page 6: Installation
Installation Important safety information! • The Scene Switch must be installed and serviced only by qualified electrical personnel. • Do not touch the terminals of the device during the testing. • Turn off all power supplying this equipment before installing. • Make sure that the power supply is off before connecting or disconnecting it to the auxiliary device. - Page 7 Follow the wiring diagram for wiring Wiring Diagram Fix the switch to the wall with screws, close the panel...
-
Page 8: Get To Know Your Device
Get to know your device The terminal is facing up LED indicator Scene1 Scene2 Scene3 Next Next Group Group Scene4 Scene1 Scene2 LED indicator... - Page 9 LED indicator The LED status gives the following information: LED status What it means Flashing slowly Enable to join a ZigBee network. When you press any button Device has not joined a ZigBee Flashing rapidly for 3 times network. Device has joined a ZigBee network/ Flashing rapidly for 1 time Active the corresponding scene.
-
Page 10: Configure Network
Configure Network 4.1 To get started, you will need: • A Zigbee Gateway. • A mobile phone with a mobile APP installed. 4.2 Adding to the gateway's network 1. Set your gateway to permit joining (see your gateway's manual). 2. Power on the Scene Switch and make sure the LED indicator is flashing slowly (If not, reset it to factory defaults).
Need help?
Do you have a question about the SLC600-S and is the answer not in the manual?
Questions and answers