Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Owon SLC600-L
Summary of Contents for Owon SLC600-L
- Page 1 SLC600-L Lighting Switch Quick Start Guide...
- Page 2 Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the Lighting Switch and other property. Read all the safety notices below before using the Lighting Switch. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light.
- Page 3 Technical Specifications Wireless Connectivity ZigBee • 2.4GHz IEEE 802.15.4 ZigBee Profile • ZigBee 3.0 • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m / RF Characteristics 30m (Open area) • Internal PCB Antenna Physical Specifications Operating Voltage • 100~250 Vac 50/60 Hz Max. Load Current • 10A (All gangs) • Temperature: -20°...
- Page 4 Welcome The Lighting Switch SLC600-L is designed to control your device On/ Off remotely and schedule for automatic switching. Each gang can be controlled separately. This guide will provide you with an overview of the product and help you get through the initial setup.
- Page 5 Installation Important safety information! • The Lighting Switch must be installed and serviced only by qualified electrical personnel. • Do not touch the terminals of the device during the testing. • Turn off all power supplying this equipment before installing. • Make sure that the power supply is off before connecting or disconnecting it to the auxiliary device.
- Page 6 Follow the wiring diagram for wiring Wiring Diagram *All lights shares the same Neutral wire Fix the switch to the wall with screws, close the panel...
- Page 7 Get to know your device L1 On/Off button & LED indicator L2 On/Off button & LED indicator LED indicator The LED status gives the following information: LED status What it means Flashing slowly Enable to join a ZigBee network. Light On The load is ON Light Off The load is OFF.
- Page 8 Configure Network 4.1 To get started, you will need: • A Zigbee Gateway. • A mobile phone with a mobile APP installed. 4.2 Adding to the gateway's network 1. Set your gateway to permit joining (see your gateway's manual). 2. Power on the Lighting Switch and make sure the LED indicator is flashing slowly (If not, reset it to factory defaults).
Need help?
Do you have a question about the SLC600-L and is the answer not in the manual?
Questions and answers