Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Owon ZigBee SLC602
Summary of Contents for Owon ZigBee SLC602
- Page 1 SLC602 ZigBee Wireless Switch Quick Start Guide...
-
Page 2: Get To Know Your Device
1. Introduction The SLC602 ZigBee Wireless Switch controls your devices such as power relay, smart plug, etc. 2. Get to know your device 2.1. SLC602 at a glance ON/OFF button Reset button & LED indicator... -
Page 3: Buttons Introduction
Release Catch 2.2. Buttons Introduction ON/OFF button Push to switch your device Reset button Return the device to default factory settings. Set the device in pairing mode to pair with your device. Release catch Push and turn in the direction of the arrow to remove from the back plate. -
Page 4: Get Started
3. Get started To get started, you will need: A SEG-X3 Smart Gateway A SLC601 power relay or another switchable device A SLC602 Dimmer Switch (with 2 x AAA battery) The mobile app Then follow the steps below: Step 1: Install the battery Remove the device from its back plates as described previously, fit the batteries and re-assemble. - Page 5 Tip: for this step, you could also press the “Z” button of the gateway for two seconds until the LED indicator turns solid blue. Step 4: Use a pin key tool to press the reset button. Then the SLC602 will try to join the gateway. The LED indicator will flash three times. Step 5: Check if the wireless switch has paired with the gateway by pressing the ON/OFF button and checking if the LED indicator does not light.
- Page 6 Ensure the SLC601 Power Relay is already setup and can be controlled by the mobile app. (1) Make sure the SLC601 is powered on. (2) Go to the “Automation” section, tap “Edit” (Android phone) or swipe from left to right (iPhone), tap the “identity” icon. Tip: for this step, you could also use a pin key tool to press and hold the reset button of the SLC601 Power Relay for three seconds.
- Page 7 (4) When pairing is successful, the LED indicator of the SLC602 Wireless Switch will flash for three times and the LED indicator of the SLC601 Power Relay will stop flashing. You are now able to use the SLC602 Wireless Switch to control the on/off status of the SLC601 power relay.
- Page 8 4. FAQ Q1. How can I return this device to default factory settings? A1: Use a pin key tool to press and hold the reset button for ten seconds until the LED indicator flashes twice. Q2. What devices can be controlled by the SLC602 Wireless Switch? A2: ZigBee devices including power relays, LED bulbs, smart plugs, etc.
-
Page 9: Technical Specifications
5. Technical Specifications Wireless Connectivity ZigBee 2.4GHz IEEE 802.15.4 Operating frequency: 2.4GHz RF Characteristics Range outdoor/indoor: 100m/30m Internal PCB antenna ZigBee Profile Home Automation Profile Type: 2 x AAA batteries Battery Voltage: 3V Battery Life: 1 year Diameter: 80mm Dimensions Thickness: 18mm Weight... -
Page 10: Safety Notice
6. Safety Notice WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the device or other property. Read all the safety notices below before using the device. Avoid high humidity or extreme temperatures. ...
Need help?
Do you have a question about the ZigBee SLC602 and is the answer not in the manual?
Questions and answers