Closing The Housing - Fantasea 15355 Instruction Manual

that the silica gel pack doesn't stick out, or else it might interfere with the watertight seal of the
housing.
5. If making use of the Vacuum System, make sure it is fully charged and turn it on prior to closing
the housing (see section "Hybrid Vacuum Safety System").

CLOSING THE HOUSING

1. Turn the housing Control Dial till the Auto
shooting mode symbol is positioned at the
left (image #14). Make sure not to accidently
turn this control any further before closing
the housing.
2. Prior to closing the housing, turn the Hybrid
Vacuum Safety System unit on using the power switch on the Signal Board (see section "Hybrid
Vacuum Safety System").
3. Turn the latch dial so that the small red tab located on the latch is pointed towards the front side
of the housing (image #15).
4. Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
5. Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #16).
Image #15
21 FRX100 VA S Housing Instruction Manual 20220601
Image #14
Image #16