Closing The Housing; Attaching Flash Housing To Arm - Fantasea FSB 800 Instruction Manual

CLOSING THE HOUSING:

Make sure the flash is set flat and that the back door of the housing closes easily without
interference.. Once the door is closed, latch the buckles in place and close.
Be sure to use a slave strobe that has the ability to ignore the built-in pre-
Note
flash in digital cameras, and synchronizes with the shutter release.

ATTACHING FLASH HOUSING TO ARM

You can either use the Fantasea Flex or Ball and Joint Arms to attach the flash housing to the
camera housing.
Insert the flat rounded end of the arm into the housing clamp and align so the threaded stainless
steel pin can be inserted.
The pin goes through the non-threaded section of the clamp first and exits through the threaded
section and is secured. There is no need for the use of force. See photo below.
The other end of the arm attaches to the housing tray or atop the contoured handles of the DSLR
and CP-8 series housings.
8