Ryobi RY905500E Operator's Manual page 22

TRANSPORTING
 Place the engine switch/fuel valve/choke lever in the OFF
position.
 Allow 30 minutes of "cool down" time before transporting
the machine. Make sure engine and exhaust of unit are
cool.
 Do not drop or strike unit or place under heavy objects.
 If transporting in a vehicle, drain the fuel tank and securely
restrain the generator.
 Provide a plastic sheet or absorbent pad below the gen-
erator to catch any drips of fuel or lubricant.
CHANGING ENGINE BATTERY CHARGE
CIRCUIT FUSE
See Figure 25.
NOTICE:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.
 Open the fuse holder.
 Remove the old fuse by pulling straight out.
 Insert new 10 amp ATO blade-type fuse.
 Close cover.
MAINTENANCE
BATTERY REMOVAL AND PREPARATION
FOR RECYCLING
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING:
Upon removal, cover the battery's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery or remove any of its components.
Lead acid batteries must be recycled or disposed of
properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Page 18 — English
To preserve natural resources, please recycle
or dispose of batteries properly.
This product uses lead acid batteries. Local,
state or federal laws may prohibit disposal of
batteries in ordinary trash.