Climadiff CLIMA10K1 Manual page 48

NOTE: This feature is unavailable under FAN or DRY mode.
⚫
Follow me/Temp sensing (optional)
NOTE: This feature can be activated from the remote control ONLY. The remote control
⚫
serves as a remote thermostat allowing for the precise temperature control at its location. To
activate the Follow Me/Temp Sensing feature, point the remote control towards the unit and
press the Follow Me/Temp Sensing button. The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing button again.
If the unit does not receive the Follow Me/Temp Sensing signal during any 7 minutes interval,
⚫
the unit will exit the Follow Me/Temp Sensing mode.
NOTE: This feature is unavailable under FAN or DRY mode.
⚫
Auto-restart (optional)
If the unit breaks off unexpectedly due to the power cut, it will restart with the previous function
•
setting automatically when the power resumes.
Air flow direction adjustment
Adjust the air flow direction manually:
• The louver can be set to the desired position manually.
Do not place any heavy objects or other loads on the louver, doing so will cause damage to
•
the unit.
Ensure the louver is fully opened under heating operation.
•
Keep the louver fully opened during operation.
•
Remote controller
Handling the remote controller
Location of the remote controller
48
Use the remote controller within a distance of 8 meters from the appliance,
pointing it towards the receiver. Reception is confirmed by a beep.