Climadiff CLIMA10K1 Manual page 47

Operation Method
Cooling mode
When the A/C enters cooling mode automatically or cooling mode is selected after power
⚫
ON, the cooling indicator lamp lights up.
Press Up/Down key to adjust setting temperature (17℃~30℃).
⚫
Press FAN SPEED on the remote controller to choose High/Low speed.
⚫
Fan mode
When pressing mode key or choosing Fan mode by pressing the remote controller, the
⚫
wind indicator lamp lights up.
Press FAN SPEED to choose High/Low speed.
⚫
Temperature can't be set.
⚫
Do not put the duct to window
⚫
Dehumidifying mode
When pressing mode key or choosing dehumidifying mode by pressing the remote
⚫
controller, the indicator lamp lights up.
After choosing this mode, operation state is determined by environmental temperature:
⚫
when environmental temperature is higher than 17℃, the operation state is the same as
that of cooling mode; when environmental temperature is lower than 15℃, the operation
state is the same as that of fan mode.
In the dehumidifying mode, the motor will work in low speed, and cannot be adjust.
⚫
In this mode, the temperature cannot be adjust.
⚫
Do not put the duct to window
⚫
Heating mode
When pressing mode key or choosing heat mode by pressing the remote controller, the
⚫
indicator lamp lights up
Press Up/Down key to adjust setting temperature (17℃~30℃).
⚫
Press FAN SPEED to choose High/Low speed.
⚫
Please put the duct to window
⚫
Sleep/Eco operation:
This feature can be activated from the remote control ONLY. To activate SLEEP feature, the
⚫
set temperature will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then increase(cooling) or decrease(heating)
⚫
by another 1°C/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it returns to the originally selected
⚫
temperature. This ends the Sleep mode and the unit will continue to operate as originally
programmed.
47